Is there a warranty on plaques and plates?
Warranties on plaques and plates provide varying coverage depending on the installation environment. Refer to the corresponding plaques or plates for warranty information.
Cast, Precision Tooled, and Etched Plaques
Cast, precision tooled, or etched plaques not installed in or parallel to the ground are covered under Gemini’s Lifetime warranty. Gemini’s Lifetime warranty means that if any Gemini-produced product fades, breaks, or contains any defect, we will refinish or replace the defective materials at no cost to you, as long as they are installed in their original location.
Cast, precision tooled, or etched plaques that are installed in the ground or run parallel to the ground are not under warranty.
Stucco Installations
Plaques installed to stucco require studs and spacers with a minimum standoff of ¼ inch. There is no warranty for plaques installed directly to stucco without the standoff. The chemicals from the stucco can create a reaction that will damage the clear coat and metal finish of the plaque.
Bronze Memorial Plaques
We guarantee our products for material for the life of the memorial. This means that if any Gemini-produced product fades, breaks, or contains any defect, we will refinish or replace the defective materials at no cost to you, as long as they are installed in their original location. Ground installation finishes are guaranteed for one year from the installation date.
Thin Gauge Plates
Interior thin gauge plates are covered under Gemini’s lifetime warranty. Limited plate products may be used for exterior applications, such as DuraLuxe. Plates can withstand different environments; however, it is not recommended for environments commonly exposed to chemicals or abrasives.
Tip: All letters and logos will require maintenance to retain their original luster. Learn more in our cleaning guide.
Warning: Neither seller nor manufacturer shall be liable for any injury, loss, or damage, director, or consequential, arising out of the use of or the inability to use the product. Before using, user shall determine the suitability of the product for his or her intended use and user assumes all risk and liability whatsoever in connection therewith. The foregoing may not be altered except by an agreement signed by officers of seller and manufacturer.
More About Plaques and Plates
5010.03